BEIL0014 Digital Making 2018 - JICHAO GUO
2018年6月11日星期一
2018年5月22日星期二
2018年4月17日星期二
The Blister
The Tray
Doing it with Kai Chang (https://yikaichang.blogspot.com.au/)
it's a IPhone 7 Plus Case and a storage for it!!!
it's a IPhone 7 Plus Case and a storage for it!!!
- Use iPhone 7 Plus as a base to get the mould
- Use hammer carefully punch four edges
- Cut extra pieces
- sand the surface
Learning:
it's hard to get the first cut steel panel to be a right perimeter. it's much easier when you punch and cut the extra parts.
it's hard to get the first cut steel panel to be a right perimeter. it's much easier when you punch and cut the extra parts.
Final:
The Torus
- Get the steel panel on a specific mould
- Use hammer to punch and once it tends to be flat then fold it
- Use cylinder mould to form two side
Learnings:
At the beginning, when you punch the panels, it tends to be
flat. Therefore, it should be bended and then punch it again.
less pressure of each punch you give will bring a better surface
Final
2018年3月13日星期二
The Bowl
- Use circle 2D form to draw the line
- Cut the edge of aluminium panel and sand the perimeter
- Use the hammer to pound and measure it with the radius tool
- Use English wheel to make the bowl smoother and rounded
Learnings:
Carefully choose the mould of
English wheel while once using the less
radius and then jump to bigger radius.
Sandpaper can be used to make the surface and edges smother
Final
订阅:
博文 (Atom)